[ivtv-users] Hauppauge HVR-1600 driver/firmware issues

[David Kirby]

On Thu, Sep 18, 2008 at 7:22 PM, Ross <rwillman at gmail.com> wrote:

> Either the cx18 didn't build or the module isn't registered... Were
> there any errors from make, make install?
> Have you run 'depmod -a'? Does the cx18.ko file exist somewhere under
> /lib/modules/kernelversion/?
>
> Ross
>
> _______________________________________________
> ivtv-users mailing list
> ivtv-users at ivtvdriver.org
> http://ivtvdriver.org/mailman/listinfo/ivtv-users
>

==========

Ross,

Thanks for the response, you were right.  I hadn't thought to check through
the make logs.  I did a make clear and another make with the logs going to a
logfile.  Sure enough, cx18 did not build.  I did another make clear and
then a make menuconfig and found that the module was not selected by
default.  It was also not named 'cx18' in menuconfig, but rather had the
chipset numbers (CX23418) in the description.

I did another make going to a logfile to verify that cx18 build, and it
did.  From there everything else went as described: make install, make
unload, modprobe cx18, reboot.

OpenSuSE 11.0 sees the card now on boot.  It does not come up in the Yast TV
Cards menu, however, mythtv-setup found and recognized it properly.

Thanks!
David
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://ivtvdriver.org/pipermail/ivtv-users/attachments/20080919/335686d4/attachment.html