[ivtv-users] cx18 module not loading

[faginbagin]

Andy Walls wrote:
> On Sat, 2010-05-22 at 11:17 -0400, J McBride wrote:
>> I have attempted to get a Hauppauge HTV-1600 card working in
>> SimpyMepis.  I have generally followed the steps in the following
>> how-to guides:
>>
>>
>> http://www.linuxtv.org/wiki/index.php/How_to_Obtain,_Build_and_Install_V4L-DVB_Device_Drivers and
>> http://ivtvdriver.org/index.php/Howto:Debian
>>
>>
>> I had to run "make config" and not configure the FireTV due to a
>> compilation error, then all seemed to work well until the command:
>> #modprobe cx18
>>
>>
>> which resulted in the error: 
>>
>>
>> FATAL: Error inserting cx18
>> (/lib/modules/2.6.32-1-mepis64-smp/kernel/drivers/media/video/cx18/cx18.ko): Unknown symbol in module, or unknown parameter (see dmesg)
>>
>>
>> Then I did:
>>
>>
>> dmesg |grep cx18
>> cx18: Unknown symbol ir_codes_hauppauge_new_table
>>
>>
>> So, I am at my limit here.  I cannot find any similar errors through
>> google. Any suggestions on how I get this to work?
> 
> Please report this to the linux-media at vger.kernel.org list.  There has
> been recent IR churn that you're running into.
> 
> I'll try to respond later today, but life's busy.  Odd's are there are
> some new IR modeuls that didn't get built.
> 
> Regards,
> Andy
> 
> 
> 
> 
> _______________________________________________
> ivtv-users mailing list
> ivtv-users at ivtvdriver.org
> http://ivtvdriver.org/mailman/listinfo/ivtv-users

If you're impatient, you might want to try an older changeset. I've been using this one from 12/7/09 and have been happy with it:
http://linuxtv.org/hg/v4l-dvb/archive/065f9e34e07b.tar.bz2

HTH,
Helen